EJOT® self-drilling screw JT6-2/5-5.0 VARIO

Applications

• To form floating and fixed points on substructures of rear-ventilated facades
• Fastening pre-drilled stainless steel or aluminium wall brackets to aluminium support profiles

Notice
Component assemblies checked with R_m (component II) ≥ 190, ≥ 215 und ≥ 245 N/mm².  For bearing values, please refer to the general building authorities test certificate (abP) P-BWU02-178006.

Properties

• A4 stainless steel with hardened drill point
• One screw for all part combinations
• Sliding washer E14, Ø 14 mm
• Buffer zone between the screw head and sliding disk prevents excessive clamp load of the joint
• Pre-assembled captive sliding washer
• Consistently low contact pressure prevents stick-slip phenomenon
• No stripping / destruction of the thread in component II resulting in high tensile loading capacity
• High tensile and transverse load transmission in component II due to fine pitch thread
• General building authorities test certificate (abP) as proof of usability according to DIN 18516-1 (also available as informal English translation)
• Case hardened drill point of the JT6 version for fastening in steel support profiles (not part of the abP)
• Wall brackets made of stainless steel and aluminium are part of the abP
• Buffer zone serves as visual set control
• Same assembly concept for floating and fixed points

Technical specifications

• Diameter: 5.0 mm
• Drilling capacity: 3.00 mm
• Drive: Hexagon A/F8
• Montagedrehzahl: 1500 1/min
• Gleitscheibe E14, Ø 14 mm